TTS, TTRS
Headlamp Beam Adjustment Motor (V48)/(V49)
Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.
• Headlamps must be adjusted after performing measures that could influence headlamp adjustment. Refer to => [ Headlamps Checking and Adjusting Conditions ] Headlamps Checking and Adjusting Conditions.
Removing
- Remove headlamp. Refer to => [ Headlamps ] Headlamps.
- Remove the safety screw - 2 -.
- Release spring clip - arrow - and remove gas discharge lamp housing cover - 1 - from headlamp housing.
- Disconnect electrical connector - 1 -.
- Remove screws - arrows -.
- By swiveling control motor - 2 -, push ball end of positioning stem downwards out of socket.
Installing
• Tightening specification, refer to => [ Bi-Xenon HID Headlamps with Cornering Lamp Overview ] Bi-Xenon HID Headlamps With Cornering Lamp Overview.
Install in reverse order of removal. Note the following:
- Start by inserting ball end of positioning stem from underneath in reflector socket. To do so, pull reflector to rear.
• Remove EVAP canister up from bracket - arrow - and lay aside with lines connected.
- Connect the connector and close the housing cover.
- Secure housing cover using wire clamp.
- Install the headlamp. Refer to => [ Headlamps ] Headlamps.