Ignition Switch (D)

Ignition Switch (D)

Removing






- Remove steering column trim. Refer to Storage Compartments and Covers.

- Destroy cover cap retainer - 2 - on the ignition switch.

- Pry off the cap - 1 - on the ignition switch.

- Disconnect electrical connector - 1 -.






- Release retaining clip by inserting jeweller's screwdrivers - 2 -.

If the procedure is not possible because there is not enough space, assisting tools must be created from 2 wire hooks as follows.






- Take a 1 mm diameter welding wire and bend the end to form an eye.

- Then cut the wire.

• Dimension - a - = approximately 50 mm (2 inch).

- File the end of the wire hook into a point.

• Dimension - b - = 5 mm (0.2 inch)

- Pull the ignition switch - item 3 - in - direction of arrow - off the steering lock housing; the jeweler's screwdriver or wire hooks must remain inserted.






Installing

Install in reverse order of removal. Note the following:

- Push the ignition switch into the steering lock housing until it audibly latches into place.