Lower Transverse Link

Lower Transverse Link

Special tools, testers and auxiliary items required

• Torque Wrench 40-200 Nm (V.A.G 1332)

Removing

- Measure dimension from center of wheel to lower edge of wheel housing. Refer to => [ Wheel Bearing, Lifting To Curb Weight Position ] Rear Suspension.

- Remove the wheel.

- Remove the coil spring. Refer to => [ Coil Spring ] Coil Spring.

- Remove the bolt - arrow - from the lower transverse link - 1 -.






- If the vehicle has a vehicle level sensor, then remove the bolts - 2 -.






- Mark, e.g. using a felt-tip marker, position of eccentric bolt - arrow B - to subframe.






- Disengage the exhaust system rear section and lower it.

- Remove bolt - arrow B -.

- Remove the lower transverse link.

Installing

Install in reverse order of removal. Note the following:

Tightening specifications, refer to => [ Subframe, Diagonal Brace, Lower Transverse Link, Upper Transverse Link, Tie Rod and Vehicle Level Sensor Overview ] Subframe, Diagonal Brace, Lower Transverse Link, Upper Transverse Link, Tie Rod and Vehicle Level Sensor Overview

Tightening specifications, refer to => [ Wheel Bearing Housing, Wheel Bearing Unit, Trailing Arm with Bracket and Stone Chip Protection Overview ] Wheel Bearing Housing, Wheel Bearing Unit, Trailing Arm With Bracket and Stone Chip Protection Overview

Tightening specifications, refer to => [ Shock Absorber and Coil Spring Overview ] Shock Absorber and Coil Spring Overview

Tightening specifications, refer to => [ Stabilizer Bar Overview ] Stabilizer Bar Overview

Transverse link connections may only be carried out of dimension between wheel hub center and lower edge of wheel housing, measured before assembly, is achieved => [ Wheel Bearing, Lifting To Curb Weight Position ] Rear Suspension.

- Observe the applied marking for the eccentric bolt - arrow B - to the subframe.






- If the vehicle has automatic head lamp range control, then perform a basic setting on the headlamps.

- If the vehicle has electronic damping (Audi Magnetic Ride), then program the control position. Refer to vehicle diagnostic tester.

- An axle alignment is necessary. Refer to the table => [ An Axle Alignment is Necessary When: ] An Axle Alignment is Necessary When: