Transmission Speed Sensor: Service and Repair

Transmission Input Speed Sensor and Clutch Oil Temperature Sensor

Removing

Proceed as follows:

Risk of transmission damage.

• Do not run engine or tow vehicle with oil pan removed or without transmission fluid.

• Observe general repair notes. Refer to => [ Repair Instructions ] Repair Instructions.

• Observe cleanliness rules when working on transmissions. Refer to => [ Clean Working Conditions ] Clean Working Conditions.

- Drain transmission fluid. Refer to => [ Transmission Fluid, Changing and Filling ] Transmission Fluid, Changing and Filling.

- Remove oil pan. Refer to => [ Oil Pan ] 02E Automatic Transmission.

- Remove direct shift gearbox (DSG) mechatronic (J743). Refer to => [ Mechatronic ] 02E Transmission.

- Remove bolt - B -.





- Remove transmission input speed (RPM) sensor (G182) and clutch oil temperature sensor (G509) - A - together with wire from transmission.

Installing

• Tightening specifications, refer to => [ Oil Pan, Mechatronic, and Transmission Oil Pump Assembly Overview ] Description and Operation, => [ and ] Description and Operation

Installation is in reverse order of removal, note the following:

- Coat transmission input speed (RPM) sensor (G182) and clutch oil temperature sensor (G509) with gear oil.

- Insert transmission input speed (RPM) sensor (G182) and clutch oil temperature sensor (G509) in side opening on transmission and tighten => [ and ] Description and Operation

- Install direct shift gearbox (DSG) mechatronic (J743). Refer to => [ Mechatronic ] 02E Transmission.

- Install oil pan. Refer to => [ Oil Pan ] 02E Automatic Transmission.

- Top off transmission oil. Refer to => [ Transmission Fluid, Changing and Filling ] Transmission Fluid, Changing and Filling and check oil level => [ Transmission Fluid, Changing and Filling ] Transmission Fluid, Changing and Filling.

- Connect vehicle diagnosis, testing, and information system (VAS 5051B).

- Perform basic setting