Windshield Wiper Motor With Control Module (J400)

Windshield Wiper Motor With Control Module (J400)

Special tools, testers and auxiliary items required

• Pry Lever (80 - 200)

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

Removing






- Remove wiper arms. Refer to => [ Windshield Wiper Arms ] Removal and Replacement.

- If equipped, remove the bolts - 3 - and - 4 -.

- Remove rubber seal - 1 -.

Danger of damaging the plenum chamber cover.

• Coat the space between the windshield and the plenum chamber cover with some soapy water.

- Carefully remove the plenum chamber cover - 2 - starting at the edge of the glass vertically from the windshield - arrows B -.

- Cut through cable ties - arrow -.






- Remove the screws - 1, 2 and 4 -.

- Pull wiper frame with linkage and wiper motor - 3 - slightly toward left in direction of travel.

- Turn windshield wiper frame with the linkage and the wiper motor up so it can be pried out of wiring clip - 6 - with (80 - 200).

• For easier removal, use silicon-free lubricating spray.

- Disconnect electrical connector - 5 -.

- Remove windshield wiper frame with linkage and motor to left in direction of travel from plenum chamber.

Installing

• Tightening specification => [ Windshield Wiper Motor Tightening Sequence ] Windshield Wiper System Overview.

Install in reverse order of removal. Note the following:

- Insert wiper motor with wiper frame into vehicle.

- Tighten bolts => [ Windshield Wiper Motor Tightening Sequence ] Windshield Wiper System Overview.

- Adjust wiper arms. Refer to => [ Windshield Wiper Arms, Adjusting ] Adjustments.