Center Rear Three-Point Seat Belt, With Foldable Rear Seat Backrest

Center Rear Three-Point Seat Belt, with Foldable Rear Seat Backrest

Removing

- Remove the bench seat. Refer to => [ Bench Seat ] Bench Seat.

- Remove the right 2/3 rear seat backrest => [ Divided Backrest ] Divided Backrest.

- Remove the cover with the upholstery:

• => [ Backrest with Pass-Through ] Backrest With Pass-Through.

• => [ Backrest with Cover or Storage Compartment ] Backrest With Cover or Storage Compartment.

Versions with rear seat belt tensioner igniter:

• Follow all safety precautions when working on pyrotechnic components.

• Follow all regulations when disposing of pyrotechnic components. Refer to => [ Airbag, Belt Tensioner and Battery Cut-Out Units, Storing, Transporting and Disposing ] Service Precautions.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Disconnect the connector - 4 -.






- To do this, release the connector lock - 3 - using a small screwdriver - 1 - and remove the electrical connector - 3 -.






All vehicles:






- Remove the nut - 1 -.

- Disengage the three-point seat belt - 2 - and remove it.

- Thread out the belt - 3 -.

Installing






- If parts of the seat belt system are removed due to an accident, replace the belt system mounting bolts.

- Insert the three-point belt with the anti-twist mechanism - 1 - in the mount - 2 - - arrow - and tighten the nut.

Versions with rear seat belt tensioner igniter:

• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

• Make sure the connectors are installed all the way in and are secure.

• Make sure the wires do not get caught.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground cable with the ignition turned on.

All vehicles:

Further installation is performed in the reverse order of removal.

Tightening specifications, refer to => [ Rear Center Three-Point Seat Belt Overview ] Rear Center Three-Point Seat Belt Overview.