Lines and Hoses Overview
Lines and Hoses Overview
Line and Hose Securing Elements, Overview
1. Reservoir bracket to body, refer to => [ Reservoir Bracket to the Body ]
2. Reservoir in bracket, refer to => [ Reservoir in the Bracket ]
3. Bolt in bracket, refer to => [ Reservoir Bracket to the Body ]
4. Hydraulic oil cooler to condenser, refer to => [ Hydraulic Oil Cooler to Condenser ]
5. Power steering pump in the bracket, refer to => [ Power Steering Pump, Vehicles with Dynamic Steering ] Power Steering Pump, Vehicles With Dynamic Steering or => [ Power Steering Pump, Vehicles without Dynamic Steering ] Power Steering Pump, Vehicles Without Dynamic Steering.
6. Pressurized line to crossbrace, refer to => [ Pressurized Line to Crossbrace ]
7. Pressure line connection installation location, refer to => [ Pressurized Line to Crossbrace ]
8. Pressurized line to the engine mount, refer to => [ Pressurized Line to the Engine Mount ]
9. Return line to the subframe, refer to => [ Return Line to Subframe ]
10. Return line bracket to the longitudinal member, refer to => [ Return Line Bracket to the Subframe ]
Reservoir Bracket to the Body
- Secure the bracket - 2 - to the body with bolts - 1 -.
- Secure the reservoir - 4 - in the bracket - 2 - using the bolt - 3 -.
Reservoir in the Bracket
- Insert the reservoir with the tab - 1 - in the opening in the bracket - 2 -.
Hydraulic Oil Cooler to Condenser
- Position the hydraulic oil cooler - 1 - on the brackets - 2 - and then engage it into the brackets - 3 -.
Lines to the hydraulic oil cooler. Refer to => [ Hose Lines to Reservoir, Hydraulic Fluid Cooler and Return Line Installed Position ] Hose Lines to Reservoir, Hydraulic Fluid Cooler and Return Line Installed Position.
Pressurized Line to Crossbrace
- Install the pressure line on the crossbrace using the nut - 3 - and rubber bushing - 4 -.
- Note the line installation location when bolting the line connection. The markings - 1 and 2 - must be opposite each other.
Pressurized Line to the Engine Mount
- Route the pressure line - 4 - between the connector - 2 - and the engine mount - 3 -.
- Tighten the retaining bracket - 5 - on the threaded pin - 1 - using the nut - 6 -.
Return Line Bracket to the Subframe
- Install the return line - 1 - on the longitudinal member threaded pins - 2 - using the clips - 5 -.
- Install the return line - 1 - with the colored markings - arrows - in the clips - 5 -.
- Secure the return line - 1 - with the line bracket - 4 - to the left front of the subframe - 3 -.
Return Line to Subframe
- Install the return line - 4 - on the subframe - 3 - using the bracket - 2 - and bolt - 1 -.