Input Shaft: Service and Repair

- Output shaft and case front section installed.
- Input shaft must rest on Synchromesh ring.





- Measure distance (A) from guide sleeve sealing surface to input shaft.





- Measure distance (B) from guide sleeve sealing surface to circlip bearing surface.





- Measure distance (C) from bearing outer race to circlip.

NOTE: Circlip must be pressed tight in groove for measuring.

EXAMPLE:
A 25.3 mm (0.996 in)
- B 10.1 mm (0.398 in)
--------------------------------
15.2 mm (0.598 in)
- C 14.0 mm (0.551 in)
--------------------------------
1.2 mm (0.047 in)

Axial play required: 1.1 to 1.3 mm (0.043 to 0.051 in).
Circlips are available from Parts in different thicknesses for making corrections.

- Install grooved ball bearing (see 23 11 014).