Parking Brake System: Adjustments
- This requires that both parking brake cables move easily.- Parking brake must be adjusted when parking brake lever can be pulled up by more than 8 teeth.
- Lift off brush cover plate (1).
- Unscrew adjusting nuts (2).
- Unscrew one wheel bolt on each rear wheel and remove.
- The tapped bore must be positioned approx. 45° behind the perpendicular line at bottom.
- Turn adjusting nut (1) with a screwdriver to move the parking brake shoes against the brake disc and prevent it from turning.
- Then turn back the adjusting nut 4 to 6 threads.
- Adjusting nut turned clockwise = tightening.
- Adjusting nut turned anticlockwise = loosening.
- Brake discs must turn easily.
Important
- When adjusting nuts are hard to turn, remove rear wheels.
- If applicable, detach brake discs.
- Pull up parking brake lever 5 teeth and turn adjusting nuts (2) until the left and right rear wheels can just be turned uniformly.
- Release parking brake lever and check whether the wheels can be turned easily.