Remove and Install
- Unscrew cap on brake fluid tank.
- Remove float container (2).
- Draw off brake fluid in tank to lower level to connection for filling pipe.
- Unscrew slave cylinder on transmission.
- Remove slave cylinder.
- Disconnect pipe (3).
NOTE: A slave cylinder with a diameter of 22.2 mm (0.874 in), instead of 20.64 mm (0.809 in), must be installed for the version with a double mass flywheel, to avoid contact of the release lever when the clutch pedal is floored.
Installation Note:
- Bleeder screw faces down.
- Install front push rod with Molykote Longterm 2.
- Bleed clutch.