Remove and Install

REMOVING AND INSTALLING WATER PUMP






Drain coolant.
Remove distributor cap (1).
Remove distributor rotor (2).
Unscrew adapter (8).
Remove cover (3).
Unscrew bolts (4).
Remove fan.

Installation:
Pour in coolant and bleed the cooling system.
Check seal (9), replacing if necessary.






Remove pulley.
Unscrew nut (4) and take off the drive belt.
Lift Out rubber part (5) and pull out the protective cover (6).

Installation:
Tighten the drive belt and check the tightness with Special Tool 11 5 020.






Compress the spring and clamp the pin with Special Tool 11 5 010.

Installation:
Check installed position of the pin to the water pump.






Disconnect coolant hoses (7 and 8).
Remove the water pump.

Installation:
Replace the gasket.