Shift Linkage: Service and Repair
REPLACING CABLE FOR SELECTOR LEVERRemove center console. Service and Repair
Lift out retainer.
Unscrew eye on pin.
Important! Don't bend the steel wire.
Unscrew nut.
Disengage cable sleeve in holder.
Loosen nuts.
Important! Don't bend the steel wire,
Unscrew nuts.
Push back cable sleeve and disconnect in holder.
Pull cable out of operating lever.
Pull out rubber grommet with cable upwards.
Installation:
Check for correct seating of rubber seals after finishing installation.
Installation:
Adjust cable.
Shift lever in "P" (most forward position).
Press cable rod opposite forward direction.
Clamp cable rod without tension.
Important!
Tightening torque = 10 to 12 Nm (7 to 9 ft lbs).
Don't bend the cable.