Defect Code 10

Defect Code 10:

Explanation:

Front right ABS solenoid valve malfunction

Possible cause:

Short or break on the wire to the ABS hydraulic unit Solenoid valve defective

Troubleshooting:

Ensure plug connection is firmly fitted at the ABS hydraulic unit and check for corrosion.

Switch off ignition and detach control unit connector. Detach connector X31 at the ABS hydraulic unit.

Check wire from the ABS/ASC+T control unit Pin 22 to ABS hydraulic unit Pin 3 and repair if necessary.

Attach connector X31 at ABS hydraulic unit.

Measure resistance at the control unit connector (X11) Pin 22/17;
Nominal value: 0.8 ... 1.5 Ohm

Measure inductance at the control unit connector (X11) Pin 22/17;
Nominal value: Approx. 3 mH

Replace ABS/ASC+T control unit If no defect can be found on the wiring harness side.