Checking Fuel Pump Delivery Pressure

Checking fuel pump delivery pressure (M52, M52TU)


Turn off ignition.







CAUTION!
The fuel in the fuel lines is under pressure (approx. 3 bar)!


Catch and dispose of escaping fuel.







Prepare special tool kit 13 5 220 (consisting of 13 5 221 and 13 5 222).
Connect special tool kit 13 5 220 to pressure sensor of DIS Tester.







Remove dust cap (1) from measuring valve on fuel rail.







Unscrew check valve (1) on special tool so that valve remains closed in fuel rail.
Attach special tool kit 13 5 220 to fuel rail and tighten down firmly so that sealing ring in special tool is sealed.







Start engine.
Screw in check valve (1) on special tool until a pressure reading is displayed at DIS Tester.


CAUTION!
Do not under any circumstances screw in the check valve up to the mechanical stop. This could damage the measuring valve in the fuel rail.







Measuring fuel pressure:
- Select measuring option.
- Multimeter function appears.
- Select pressure test.
- Read off pressure.

Test pressure,
refer to Technical Data.

Injectors And Lines, Fuel Pressure Regulator M52:

Switch off engine.







Checking fuel pump:
E39:
Detach fuel pump relay (2).







E46:
Remove fuel pump relay,







E38:
Remove fuel pump relay,







Connect up special tool 61 3 050 to terminal 87b and terminal 30.
Operate button for approx. 10 sec and read off delivery pressure at DIS Tester.







NOTE:
Removing special tool kit 13 5 220:
- Switch off engine.
- Screw out check valve again fully.
- Remove special tool kit 13 5 220 from pressure regulator housing.
- Catch and dispose of escaping fuel.

Interrogate fault memory of DME control unit. Check stored fault messages. Rectify faults. Now clear the fault memory.