Removing and Installing Oddments Tray

51 16 200 Removing And Installing Oddments Tray

Removing and installing finisher for preselector lever.
Removing and installing heater controls.
Removing and installing switch for hazard warning lights.
Removing and installing switch for central locking.
Removing and installing switch for automatic stability control.
If necessary, remove and install both switches for seat heating.
If necessary, remove and install switch for rear window roller blind.
If necessary, remove and install switch for electronic damper control.
Removing and installing fresh air grille in luggage compartment.







Unfasten screws on left/right sides.
Pull left/right side carpet backwards out of clips.







Unfasten left/right screws.







Lift off caps (1) and unfasten screws.
Unclip rubber gaiter (2).







Unfasten screw and unclip finisher.







Installation: Tab for clip mounting must not be damaged.







Unfasten screws.







Lift off left/right and unfasten screws.







Unscrew screw.







Raise back of oddments tray (1) slightly and cut through plug connection (cigarette lighter).







Adjust both front seats, back-rests and selector lever as far backwards and downwards as possible.
Lift up rear oddments tray and pull out on passenger side.