Replacing Steering Column

Replacing Steering Column


Caution!
After installation, carry out mechanical (locking cylinder, steering lock, interlock) and electrical (e.g. ignition, radio etc.) function checks.

Remove steering wheel.
Remove upper and lower sections of steering column trim.
Remove panel for pedal assembly.
Remove lower section of steering spindle.





Unfasten screws.
Disconnect all plugs and remove switch block.
Disconnect plug from ring antenna.





Pull upper section of steering spindle towards interior.

If necessary, remove interlock cable.

Installation:





Lock (1) must snap into place.





Unlock connector and remove.
Detach wiring harness from cable duct.





Release shear screw (1) (e.g. mill off or drill out).
Release screw (2).

Installation:
Tighten down new shear screw until screw head shears off.





Unfasten screws.
Remove steering column.