Removing and Installing/Replacing Outside Handle and Lock Actuator on Left or Right Rear Door (From 09/00)
51 22 200 Removing And Installing/Replacing Outside Handle And Lock Actuator On Left Or Right Rear Door (From 09/00)
NOTE:
- The lock actuator has a Bowden cable from year of manufacture 09/2000.
- Remove acoustic insulation.
- Remove outside handle on rear door.
Remove seals (1) and (2) for outside handle.
Lever out Bowden cable (1) from holder (2) with screwdriver.
CAUTION: Do not bend holder (2).
Unhook Bowden cable nipple (3) from lever (4).
Feed Bowden cable (1) out of guide (2).
Installation:
Foam (3) must be in area of guide (2).
NOTE: Shown in illustration without window guide rail.
Loosen bolt (1).
Lever out lock actuator (2) towards front and remove to inner door plate.
Installation:
Grommet (3) must be pushed onto end piece (4).
NOTE:
- Bowden cable nipple (1) for rear door.
- Bowden cable nipple (2) for 2-door model only on front door.
Installation:
If necessary, replace screw (1) on lock actuator (3).
Bowden cable (2) must be correctly engaged with lock actuator (3).
Installation:
Bowden cable nipple (1) must be correctly fitted in lock actuator (2) and must not be removed.