DME Main Relay

DME Main Relay

DME main relay
The relay is driven by the DME control module.

Function of main relay:
Voltage supply to all components in the engine electrical/electronic system
Possible effects: - Engine does not run

Diagnosis note
The fault codes below can be entered in any combination in the DME fault code memory if the system voltage was too low due to battery discharge or due to failure or contact fault of the DME main relay.

If fault code (036) 24 - main relay is stored in the DME, all fault code entries listed below that were stored at the same km reading (mileage) are to be ignored and deleted. The DME control module should on no account be replaced.

Possible consequential fault codes of the main relay fault (036) 24:
(019) 13 - Activation, VANOS solenoid valve, outlet
(021) 15 - Activation, VANOS solenoid valve, inlet
(027) 1B - Activation, idle actuator/closing coil
(053) 35 - Activation, idle actuator/opening coil
(068) 44 - Activation, solenoid valve, fuel tank ventilation
(069) 45 - Activation, electronic fuel pump
(110) 6E - Signal, pedal-position sensor 1
(112) 70 - Signal, throttle position sensor, potentiometer 1
(115) 73 - Reference voltage, voltage regulator 1
(123) 7B - Activation, characteristic map cooling
(124) 7C - Activation, intake pipe solenoid valve (DISA)
(217) D9 - Signal, CAN EGS