Ignition Switch: Service and Repair

61 31 020 - Removing and installing/replacing ignition starter switch





Necessary preliminary tasks:
- Move ignition lock to key position 0 (stop)
- Remove lower section of steering column trim Removing and Installing/Replacing Lower Section of Steering Column Trim





Important!
Before removing ignition starter switch (1), secure inner shaft against turning:
Insert a M2.5*8 screw in bore (2).

Installation:
Remove screw in bore (2).





Release screws (1), tightening torque 61 31 1AZ Specifications.

Installation:
Secure screws (1) with sealing paint.

Important!
Carefully unlock and disconnect associated plug connection for ribbon cable.
Replace the ribbon cable if damaged.
The ribbon cable leads to the control unit for the Car Access System Service and Repair.

Remove ignition starter switch (2).