51 47 072 Removing and Installing/Replacing Finishing Strip At Rear Left or Right Entrance

51 47 072 Removing And Installing/Replacing Finishing Strip At Rear Left Or Right Entrance







The notes on component bonding with double-sided adhesive tape serve as the basis for these repair instructions and must be observed without fail.
Cover can not be reused.







Detach cover (1) and dispose of it.
Clean bonding surface.
Bond on new cover (1) in accordance with dimension (x and y).
x = 4 to 4.5 mm parallel to entrance edge
y = Align cover (1) to joint of cover (2)

NOTE: If the cover (1) is only replaced on one side, the dimensions (x and y) from the other side must be used.