Parking Brake System: Adjustments

34 41 006 Adjusting parking brake





The parking brake test must be carried out on the dynamic brake analyzer as follows.

Release position:
^ Wheel circumferential force right / left ≥ 300 N.

Press parking brake button:
^ Car must be pulled uniformly out of brake roller or drive of brake roller is deactivated on both sides.





Note:
Accurate adjustment of the parking brake is only possible if the parking brake Bowden cables and all moving parts on the parking brake move easily and function correctly.

Basic setting of the parking brake is required:
- After replacing brake shoes
- Brake discs are replaced





1. Adjustment specification for brake shoes

Release parking brake (switch on centre console).

Approach installation position using BMW diagnosis system.

Completely unscrew one wheel stud on each rear wheel.

Installation:
Install and tighten wheel bolt.

Tightening torque, 36 10 1AZ.





Turn adjusting screw with a screwdriver until it is no longer possible to turn the wheel.

Then unfasten the adjusting screw 10 notches.





2. Braking in duo-servo parking brake
2.1 On brake dynamometer:
2.1.1 Call up braking-in program via diagnosis interface using DIS diagnosis system.
(Parking brake indicator lamp in instrument cluster flashes at low frequency)
2.1.2 Drive vehicle onto brake analyzer and pull parking brake button once.
2.1.3 Parking brake is applied at approx. 15 km/h with reduced force.
(Parking brake indicator lamp in instrument cluster flashes at high frequency)
2.1.4 Braking-in procedure takes 3 minutes.
2.1.5 Braking-in procedure can be terminated by pressing the parking brake button.
2.1.6 Delete fault memory.
2.2 When road-testing (if possible on company property or an unused road):
2.2.1 Call up braking-in program via diagnosis interface using DIS diagnosis system.
(Parking brake indicator lamp in instrument cluster flashes at low frequency)
2.2.2 Pull parking brake button once.
Increase driving speed to 15 km/h, braking-in distance is 400 meters.
2.2.3 Parking brake is applied with reduced force.
(Parking brake indicator lamp in instrument cluster flashes at high frequency)
2.2.4 Braking-in procedure can be terminated by pressing the parking brake button.
2.1.6 Delete fault memory.