Mechanical Specifications

Front Brakes

Caliper Bore Diameter 64 mm 2.520 in
Rotor Diameter (All Wheel Drive) 300 mm 11.811 in
Rotor Diameter (Front Wheel Drive) 275 mm 10.945 in
Rotor Discard Thickness* 27.0 mm 1.063 in
Rotor Maximum Allowable Assembled Lateral Runout 0.06 mm 0.002 in
Rotor Maximum Allowable Scoring 1.50 mm 0.059 in
Rotor Maximum Allowable Thickness Variation 0.025 mm 0.001 in
Rotor Minimum Allowable Thickness After Refinish 28.4 mm 1.118 in
Rotor Minimum Wear Stock 1.0 mm 0.039 in
Rotor Thickness (new) 30.0 mm 1.181 in

Rear Brakes

Caliper Bore Diameter 38.1 mm 1.500 in
Rotor Diameter 291.0 mm 11.457 in
Rotor Discard Thickness* 9.0 mm 0.35 in
Rotor Maximum Allowable Assembled Lateral Runout 0.06 mm 0.002 in
Rotor Maximum Allowable Scoring 1.50 mm 0.059 in
Rotor Maximum Allowable Thickness Variation 0.025 mm 0.001 in
Rotor Minimum Allowable Thickness After Refinish 10.6 mm 0.42 in
Rotor Minimum Wear Stock 1.6 mm 0.06 in
Rotor Thickness (new) 11.0 mm 0.43 in

* All brake rotors have a discard dimension cast into them. Replace any rotor that does not meet this specification. After refinishing the rotor, replace any rotor that does not meet the minimum thickness specifications.

The content of this article has been updated by manual update # 04-05-23-002A dated August 4, 2005 for Rotor Minimum Allowable Thickness After Refinish.