74. Oil Pump Installation
Oil Pump Installation1. Install the crankshaft oil deflector.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the crankshaft oil deflector nuts.
Tighten the crankshaft oil deflector nuts to 25 Nm (18 ft. lbs.).
Important: Do not reuse the oil pump driveshaft retainer. During assembly, install a NEW oil pump driveshaft retainer.
3. Install the oil pump.
4. Position the oil pump onto the pins.
5. Install the oil pump bolt attaching the oil pump to the rear crankshaft bearing cap.
Tighten the oil pump bolt to 41 Nm (30 ft. lbs.).