Console Electrical Center or Junction Block Replacement
CONSOLE ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENTREMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the front floor console.
3. Disconnect the body control module (BCM) electrical connectors (1, 2, 3).
4. Disconnect the console accessory wiring junction block electrical connectors (1, 2).
5. Release the console accessory wiring junction block retainers (1).
6. Remove the console accessory wiring junction block (2) out of the console accessory wiring junction block bracket.
7. Remove the BCM.
INSTALLATION PROCEDURE
1. Install the BCM.
2. Install the console accessory wiring junction block (2) into the console accessory wiring junction block bracket.
3. Secure the console accessory wiring junction block retainers (1).
4. Connect the console accessory wiring junction block electrical connectors (1, 2).
Install the console accessory wiring junction block electrical connectors bolts (1, 2) finger tight until seated.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the console accessory wiring junction block electrical connectors bolts to 6 N.m (54 lb in).
5. Connect the BCM electrical connectors (1, 2, 3).
6. Install the front floor console.
7. Connect the negative battery cable.