Tire Monitoring System: Service and Repair
Tire Pressure Monitor Reset ProcedureImportant: After resetting, the TPM system requires up to 8 km/h (5 miles) of flat, smooth road, straight line driving in each of the 4 speed ranges to complete the calibration process. If the TPM system does not reset, refer to Driver Information Center (DIC) Switch(es) Inoperative.
Using the DIC
1. Set all tire pressures to the recommended kPa/psi.
2. Turn ON the ignition, with the engine off.
3. Press the MODE button until LOW TIRE PRESSURE HOLD SET TO RESET is displayed.
4. Press and hold the SET button until a chime sounds and TIRE PRESSURE RESET is displayed and a chime sounds 3 times.
5. Release the SET button and TIRE PRESSURE NORMAL is displayed.