Operation CHARM: Car repair manuals for everyone.

Symptom Related Diagnostic Procedures

SYMPTOM DIAGNOSIS

Intermittent No Crank: Refer to TSB# 92-8-24
SECURITY light on for Dated May '92
2 - 5 seconds, then
goes out when attempting
to start vehicle.

No Crank: SECURITY Indicator Do TEST A - do 1st
does not light during System Do TEST C - do 2nd
Check.

No Crank: SECURITY Indicator Do TEST A - do 1st
is continuously lit. Do TEST C - do 2nd

No Crank: SECURITY Indicator Do TEST D
operates normally.

Crank But No Start: PCM code Do TEST E
58 may be present.

SECURITY Indicator does not Do TEST B
light during System Check -
Normal Operation (Forced
Entry)

SECURITY Indicator does not Do TEST F
light during System Check -
Normal Operation (PASS-Key)
engine starts.

SECURITY Indicator stays on Do TEST G
with Ignition Switch at RUN;
engine starts.

SECURITY Indicator is Check DK GRN (264) wire, PASS-Key Decoder
continuously lit with Module and Remote Accessory (RAC) Module
Ignition Switch at OFF. for shorts to ground.


Alarm functions do Do TEST H - do 1st
not operate. Do TEST B - do 2nd

False alarm. Do TEST I

Horns do not sound; Do TEST B
lights flash during alarm.

Light do not flash; Do TEST B
horns sound during alarm.

System does not disarm and/or Do TEST B
cancel when commanded by key
switch and door switch.


Note: Theft Deterrent System allows a bidirectional scan tool to activate/monitor the following theft related outputs and inputs.

Inputs
^ LH/RH Front Door Lock Cylinder Switch input - if scan tool indicates inoperative switch, do Remote Accessory Control (RAC) Module Input/Output Test B and check terminal A.
^ Tamper switch input - if scan tool indicates a closed tamper switch, do Tamper Switch Test H.

Outputs
^ Headlights alarm output - if inoperative, do Remote Accessory Control (RAC) Module Input/Output Test B, check terminal G.
^ Horn alarm output - if inoperative, do Remote Accessory Control (RAC) Module Input/Output Test B, check terminal H.
^ SECURITY Indicator control output - if inoperative, do Remote Accessory Control (RAC) Module Input/Output Test B, check terminal C.