Keyless Entry: Service and Repair

RH Side Of Trunk:

^ Do the following procedure whenever the Keyless Programming Connector is grounded, the Remote Keyless Entry (RKE) Module is replaced, the Portable Transmitter is replaced or a second Transmitter is added.
1. Jumper the Program Connector to Ground (all power door locks will lock and unlock).
2. Operate Transmitter by pressing a single button once.
3. To program for a second Portable Transmitter, operate Transmitter 2 by pressing a single button once. In order for programming to be complete, wait after each button is pressed for the locks to fully cycle.
4. Disconnect Program Connector Jumper after locks have finished cycling.
5. Verify that the Portable Transmitter(s) operate Door Locks and Trunk Lid Release.
^ Refer to System Diagnosis. [1][2]A Symptom Table