Vehicle Speed Sensor: Service and Repair

Speed Sensor And Governor Assemblies - 3T40 Transaxle:

REMOVAL
1. Rotate engine forward.
2. Disconnect speed sensor electrical connector from transaxle.
3. Remove governor cover bolts, cover and O-ring with speed sensor attached.
4. Remove speed sensor O-ring, screws and sensor.

INSTALLATION
1. Install speed sensor, screws and O-ring. Tighten screw to 9 N-m (80 lb. in.).
2. Install governor cover, O-ring, gasket and cover with speed sensor attached. Tighten screw to 11 N-m (98 lb. in.).
3. Reconnect speed sensor electrical connector.
4. Properly position engine.