Ignition Control Module: Service and Repair

REMOVE OR DISCONNECT
1. Remove all the electrical connectors at the ignition control module.
2. Note position of spark plug wires for installation
3. Remove the spark plug wires from ignition coils.
4. Remove the screws securing coil assemblies to ignition control module.
5. Disconnect coils from ignition control module.
6. Remove the fasteners securing ignition control module assembly to engine.
7. Remove the ignition control module.

INSTALL OR CONNECT
1. Install the coils to ignition control module.
2. Install the screws.

Tighten
Screws to 4-5 Nm (40 lb in.).

3. Install the fasteners securing assembly to engine.

Tighten
Fasteners to 8 Nm (70 lb in.).

4. Install the spark plug wires as noted during removal.
5. Install the electrical connectors to the ignition control module.