Dimension Specifications

GENERAL SPECIFICATIONS
Brake Pedal Travel 74 mm (2.91")

DIMENSIONS SPECIFICATIONS

Master Cylinder Bore 25.4 mm (1.000")

Caliper Bore Diameter (Front) 63.5 mm (2.500")

Caliper Bore Diameter (Rear) 38.0 mm (1.500")

Front Disc Brakes:

Rotor Diameter 278.0 mm (10.945")

Maximum Lateral Run-out 0.080 mm (0.003")

Thickness Variation Maximum 0.013 mm (.0005")

Maximum Scoring 1.50 mm (0.059")

Rotor Thickness (new) 32.2 mm (1.27")

Minimum Rotor Thickness 31.7 mm (1.25")

Discard Thickness (A) 30.7 mm (1.21")

Minimum Wear Stock 1.0 mm (0.039")

Rear Disc Brakes:

Rotor Diameter 278.0 mm (10.945")

Maximum Lateral Run-out 0.08 mm (0.003")

Thickness Variation Maximum 0.013 mm (.0005")

Maximum Scoring 1.50 mm (0.059")

Rotor Thickness (new) 11.0 mm (0.4311)

Minimum Rotor Thickness 10.6 mm (0.4111)

Discard Thickness (A) 9.0 mm (0.35")

Minimum Wear Stock 1.6 mm (0.06")

Rear Drum Brakes:

Inside Diameter 225.12 mm (8.863")

Maximum Lateral Run-out 0.15 mm (0.006")

Maximum Rebore Diameter (A) 226.57 mm (8.920")

Discard Diameter (A) 226.30 mm (8.909")

Wheel Cylinder Bore Diameter 22.20 mm (0.874")


(A) All brake drums arid rotors have a discard dimension cast into them. Replace any drum or rotor that does not meet this specification. After refinishing drums or rotors, replace any drum or rotor that does not meet the maximum rebore diameter or minimum thickness after refinish specifications.