Catalytic Converter: Service and Repair
NOTE: The front pipe and catalytic converter is serviced as an assembly. They are not serviced separately.
Remove or Disconnect
1. Oxygen sensor.
2. Support catalytic converter and cut exhaust pipe. Use J 29800.
3. Front exhaust pipe bolts.
4. Seal.
5. Front exhaust pipe/catalytic converter assembly.
Install or Connect
1. Front exhaust pipe/catalytic converter assembly using a "U" bolt type clamp (position clamp so nuts are toward the drivers side of vehicle).
2. Seal.
3. Front exhaust pipe to manifold.
Tighten
^ Bolt to 25 Nm (18 lb. ft.).
^ Clamp nuts to 40 Nm (30 lb. ft.).
4. Oxygen sensor.