Reverse Band Servo Assemble

1. Inspect the reverse band servo components for the following conditions:
^ Damaged, worn or porous servo piston (44)
^ Damaged servo piston seal (43)
^ Damaged, worn or porous servo cover(40)
^ Damaged servo cover seal (41)
^ Damaged servo cover retaining ring (39)
^ Broken or collapsed servo piston spring (49)
^ Broken or collapsed servo piston cushion springs (45, 47)
^ Damaged or worn servo piston pin (48)





2. Assemble the servo piston (44), servo piston cushion springs (45, 47), servo piston retainer (46) and servo piston pin (48).
3. Install the servo pin retaining ring (42) onto the servo piston pin (48).
4. Install the servo piston oil seal ring (43) onto the servo piston (44).
5. Assemble the servo piston spring (49) onto the servo assembly.





6. Position the transaxle so that the oil pan is facing down.
7. Install the servo cover seal (41) onto the servo cover (40).
8. Install the servo and cover assembly into the case.





9. Use a long screwdriver in order to depress the reverse band servo cover (40) by prying against the transmission holding fixture.
10. Hold servo assembly compressed.
11. Use a small screwdriver in order to install the reverse band servo cover retaining ring (39).
12. Remove the long screwdriver.