Instrument Panel (IP) - Trim Pad Replacement - Upper

REMOVAL PROCEDURE
1. Perform the following steps in order to remove the reveal covers (1):
1.1. Pry the covers up.
1.2. Carefully pull forward on the covers.
2. Remove the fasteners (2):
3. Carefully pull up the upper trim panel (5).
4. Remove the sunload and the twilight sentinel sensors.
5. Remove the upper trim panel.

INSTALLATION PROCEDURE
1. Partially install the IP upper trim panel (5).
2. Insert the sensors. Refer to Sunload and Twilight Sentinel Sensor Replacement.
3. Install the upper trim panel.

NOTE: Refer to Fastener Notice in Cautions and Notices.

4. Install the fasteners.

Tighten
Tighten the fasteners to 1.9 N.m (17 lb in).

5. Install the reveal covers (1).