Power Door Lock Switch: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.
2. Remove the fastener retaining the switch plate escutcheon to the trim panel.
3. Use a thin flat-bladed tool to partially remove the switch plate.
4. Disengage the switch plate retainer clips. Insert a small, flat-bladed tool between the switch plate and the trim panel.
5. Disconnect the electrical connectors.
6. Remove the door lock switch.

INSTALLATION PROCEDURE
1. Install the door lock switch to the switch plate.
2. Connect the electrical connectors.
3. Carefully guide the switch plate in the trim panel.
4. Ensure the lock rod is aligned properly to the lock rod knob on the switch plate.
5. Push inward the switch plate in order to secure.

NOTE: Refer to Fastener Notice in Cautions and Notices.

6. Install the retaining fastener.

Tighten
Tighten the fastener to 1.2 N.m (11 lb in).

7. Connect the negative battery cable.