Daytime Running Lamp Resistor: Service and Repair

REMOVAL PROCEDURE
1. Remove the air cleaner assembly.
2. Remove the PCM cover.
3. Remove the resistor screw (2-Buick, 4-Pontiac/Oldsmobile) from the front fender.
4. Disconnect the connector.
5. Remove the daytime running lamp resistor (1-Pontiac/Oldsmobile, 3-Buick).

INSTALLATION PROCEDURE
1. Connect the connector to the daytime running lamp resistor (1-Pontiac/Oldsmobile, 3-Buick).
2. Connect the daytime running lamp resistor (1-Pontiac/Oldsmobile, 3-Buick) to the front fender.

NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the resistor screw (2-Buick, 4-Pontiac/Oldsmobile) to the front fender.

Tighten
Tighten the screw (2-Buick, 4-Pontiac/Oldsmobile) to 7 N.m (62 lb in).

4. Install the PCM cover.
5. Install the air cleaner assembly.