Tail Lamp: Service and Repair

REMOVAL PROCEDURE
1. Remove the rear compartment sill panel trim.
2. Remove the nuts (1) that retain the taillamp (2).
3. Disconnect the lamp harness electrical connector.
4. Remove the taillamp (2).

INSTALLATION PROCEDURE
1. Install the taillamp (2).
2. Connect the lamp harness electrical connector.

NOTE: Refer to Fastener Notice in Cautions and Notices.

IMPORTANT: Do not rework or alter the reflective surface of the taillamps (2).

3. Install the nuts (1) in order to retain the taillamp (2).

Tighten
Tighten the nuts (1) to 6 N.m (53 lb in).

4. Install the rear compartment sill panel trim.