Left

1. Connect the load bar assembly to the seat adjuster using a 3/16-inch rivet.
2. Connect the buckle assembly to the load bar assembly and secure with a nut.

Tighten
Tighten the nut to 28 N.m (21 lb ft).

Notice: Refer to Fastener Notice in Cautions and Notices.

Caution: Make sure bolt is through both parts. Failure to do so will result in system failure, leading to injury in the event of a collision.

3. Install the seat assembly. Secure the nuts to the seat adjuster and bolt for the center lap belt and the load bar assembly. 4. Connect the electrical connector to the seat harness (drivers side only).