Power Seat Switch: Service and Repair

REMOVAL PROCEDURE



1. Remove the fasteners (2) attaching the seat switch bezel to the seat.
2. Partially remove the switch bezel (1).
3. Disconnect the electrical connector.
4. Remove the seat switch.

INSTALLATION PROCEDURE



1. Install the seat switch.
2. Connect the electrical connectors.
3. Install the switch bezel to the seat.
4. Install the fasteners (2).
5. Verify that the seat operates correctly.




NOTE: Refer to Fastener Notice in Cautions and Notices.

6. Install the lap belt nuts (3).

Tighten
Tighten the lap belt nuts to 35 N.m (25 lb ft).

7. Verify that the shoulder belts (4) operate freely.
8. Install the rear seat cushion.