Ride Height Sensor: Service and Repair

REMOVAL PROCEDURE





1. Raise the vehicle. Refer to Vehicle Lift Points.
2. Disconnect the link from the height sensor actuating arm and the suspension control arm.





3. Remove the height sensor connector from the vehicle harness connector.
4. Remove the height sensor harness clip and the connector from the vehicle.
5. Remove the two bolts and the height sensor with the bracket from the vehicle.
6. Remove the four nuts and the bracket from the height sensor.

INSTALLATION PROCEDURE

NOTICE: Refer to Fastener Notice in Service Precautions.





1. Install the bracket on the height sensor with four nuts.
- Tighten four nuts to 3 Nm (26 inch lbs.).

2. Install the height sensor with the bracket on the vehicle with two bolts.
- Tighten two bolts to 5 Nm (44 inch lbs.).

3. Connect the height sensor harness clip and the connector to the vehicle.
4. Connect the height sensor connector to the vehicle harness connector.





5. Connect the link to the height sensor actuating arm and the suspension control arm.
6. Lower the vehicle. Refer to Vehicle Lift Points.
7. Adjust the height sensor. Refer to Trim Height Sensor Adjustment.