Ignition Switch - Assemble
ASSEMBLY PROCEDURE
^ Connect the ignition switch assembly (5) to the steering column jacket assembly secure with the ignition switch mounting stud (1). Tighten finger tight.
^ Align the ignition switch actuator assembly with the ignition switch assembly (5).
^ Move the ignition switch assembly slider (2) to the far right position.
^ Move the ignition switch assembly slider (2) detent to the left. This is the "OFF LOCK" position.
^ Install a 3/32 inch drill bit into the hole on the ignition switch assembly (1) to limit travel.
NOTICE: Refer to Fastener Notice in Service Precautions.
^ Tighten the stud to 4 Nm (35 inch lbs.).
^ Remove the 3/32 inch drill bit.
^ Install the dimmer switch assembly. Refer to Dimmer Switch Assembly - Assemble.