Front Suspension

REMOVAL PROCEDURE

- Tools Required
- J 21474 - 18 Nut
- J 21474 - 5 Bushing Receiver
- J 21474 - 13 Bushing Driver
- J 21474 - 19 Bolt Assembly





1. Remove the control arm from the vehicle. Refer to Lower Control Arm Replacement.
2. Assemble the bushing tool as follows:
2.1. Assemble the J 21474-19 through the J 21474-13 with the small end facing the bushing.
2.2. Assemble J 21474-5 on the front of the bushing.

3. Tighten the bolt until the bushing is driven out of the frame.
4. Remove the bushing driver tool.

INSTALLATION PROCEDURE





1. Install the bushing to the frame as follows:
1.1. Assemble the J 21474-19 through J 21474-5 with the large end facing the bushing.
1.2. Assemble the large end of the J21474-13 facing the bushing.
1.3. Connect the J 21474-18 to the threads.

NOTICE: Refer to Fastener Notice in Service Precautions.

2. Install the J 21474-19.
- Tighten bolt J 21474-19 until the bushing is fully seated.

3. Remove the bushing driver tool.
4. Install the control arm to the frame. Refer to Lower Control Arm Replacement.