Installation Procedure

Installation Procedure

Notice: Refer to Fastener Notice in Cautions and Notices.

1. Install the lap retractor and the anchor bolt.

Tighten
Tighten the lap retractor anchor bolt to 41 N.m (30 lb ft).

2. Install the lap retractor trim cover and the screw.

Tighten
Tighten the trim cover screw to 2.0 N.m (18 lb in).

3. Install the guide loop and the anchor bolt.

Tighten
Tighten the guide loop anchor bolt to 41 N.m (30 lb ft).

4. Install the intermediate guide and the bolt.

Tighten
Tighten the intermediate guide bolt to 41 N.m (30 lb ft).

5. Install the retractor and the anchor bolt.

Tighten
Tighten the retractor anchor bolt to 41 N.m (30 lb ft).

6. Connect the electrical connector at the shoulder retractor.
7. Install the quarter trim panel.
8. Install the lap belt nuts and the rear seat back.

Tighten
Tighten the lap belt nuts to 30 N.m (22 lb ft).

9. Install the rear seat cushion.
10. Install the escutcheon onto the rear quarter panel and the screw.
11. Install the shoulder belt guide to the seat.
12. Install the two shoulder belt guide screws.

Tighten
Tighten the two shoulder belt guide screws to 2.0 N.m (18 lb in).