Rear

REAR WHEEL BEARING/HUB

REMOVAL PROCEDURE
1. Raise the vehicle. Refer to Vehicle Lifting.





2. Remove the wheel and the tire. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
3. Remove the two bolts and the brake caliper. Refer to Brake Caliper Replacement - Front in Disc Brake Systems. Support the caliper.
4. Remove the brake rotor. Refer to Brake Rotor Replacement in Disc Brake Systems.
5. Remove the ABS sensor wire connector.
6. Remove the four bolts from the control arm.
7. Remove the hub and bearing from the control arm.
8. Remove the brake shield from the control arm.
9. Clean the control arm face and the bore before installing the hub and the bearing.

INSTALLATION PROCEDURE





1. Install the brake shield and the hub and the bearing to the control arm with the four bolts. Be careful not to drop the hub and the bearing, as it could be damaged. Reconnect the ABS sensor.
Tighten the hub and bearing bolts to 70 Nm (52 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the brake rotor. Refer to Brake Rotor Replacement in Disc Brake Systems.
3. Install the brake caliper. Refer to Brake Caliper Replacement - Front in Disc Brake Systems.
4. Install the wheel and the tire. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
Tighten the wheel nuts to 140 Nm (100 ft. lbs.).
5. Lower the vehicle.