Heater Core Replacement - With RPO DO7
TOOLS REQUIREDJ 38185 Hose Clamp Pliers
REMOVAL PROCEDURE
1. Drain the cooling system. Refer to Draining and Filling Cooling System in Cooling System.
2. Remove the fuel injector sight shield.
3. Position the J 38185 in order to remove the heater hose clamps.
4. Remove the heater hoses from the heater core.
5. Remove the left side sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges and Warning Indicators.
6. Remove the right side sound insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gauges and Warning Indicators.
7. Remove the auxiliary air distribution duct adapter.
8. Remove the air distributor duct screws (1,2). Due to the difficulty in the removal of the right side screw (2), it will not be necessary to install upon reassembly.
9. Remove the air distributor duct.
10. Remove the heater core heat shield screws.
11. Remove the heater core heat shield.
12. Remove the heater core cover screws (1).
13. Remove the heater core cover.
14. Remove the retaining screw and strap from the heater core.
15. Remove the heater core.
INSTALLATION PROCEDURE
1. Install the heater core into the HVAC module.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Secure the heater core into the HVAC module using the attaching straps and screws.
Tighten
Tighten the screw to 1.4 N.m (12 lb in).
3. Install the heater core cover.
4. Ensuring the seals at the front of dash are in the proper positions, install the heater core cover screws.
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
5. Install the heater core heat shield and screws (1).
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
6. Install the air distributor duct.
7. Install the air distributor duct left side screw (1). Ensure the right side tab is seated properly.
Tighten
Tighten the screw to 1.4 N.m (12 lb in).
8. Install the auxiliary air distribution duct adapter.
9. Install the left side sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gauges and Warning Indicators.
10. Install the right side sound insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gauges and Warning Indicators.
11. Install the heater hoses and clamps using the J 38185.
12. Install the fuel injector sight shield.
13. Fill the cooling system. Refer to Draining and Filling Cooling System in Cooling System.
"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID". RPO Codes