HVAC System - Automatic

REMOVAL PROCEDURE




1. Remove the right sound insulator. Refer to Closeout/Insulator Panel Replacement - Right In Instrument Panel, Gauges and Console.
2. Remove the instrument panel compartment.
3. Remove the Dash Integration Module (DIM) from the bracket and position aside.
4. Remove the rear DIM bracket screws and lower the bracket enough to access the blower module.
5. Disconnect the electrical connector (1).
6. Remove the blower motor control processor retaining screw.
7. Remove the blower motor control processor.

INSTALLATION PROCEDURE




1. Install the blower motor control processor.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the retaining screw.

Tighten
Tighten the bolt to 2 N.m (18 lb in).

3. Connect the electrical connector (1).
4. Install the DIM bracket screws.

Tighten
Tighten the screw to 1.4 N.m (12 lb in).

5. Install the DIM into the bracket.
6. Install the instrument panel compartment.
7. Install the right sound insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gauges and Warning Indicators.