Headlamp Switch: Service and Repair
HEADLAMP SWITCH REPLACEMENTREMOVAL PROCEDURE
1. Remove the left IP trim plate. Refer to Trim Plate Replacement - IP Accessory Left in Instrument Panel, Gauges and Warning Indicators.
2. Disconnect the electrical connectors (2,3).
3. Remove the headlamp switch from the left IP trim plate.
3.1. Remove the fastener (1).
3.2. Tilt the headlamp switch (2) to remove.
INSTALLATION PROCEDURE
1. Install the headlamp switch (2) to the IP trim plate.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the fastener (1).
Tighten
Tighten the fastener to 2 N.m (18 lb in).
3. Connect the electrical connectors (2,3).
4. Install the IP trim plate. Refer to Trim Plate Replacement - IP Accessory Left in Instrument Panel, Gauges and Warning Indicators.