Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring

Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement - On Vehicle

- Tools Required
- J23653-SIR Steering Column Lock Plate

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.

1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in Restraint Systems.
3. Install J23653-SIR to the upper steering shaft.
4. Using J23653-SIR depress the lock plate and remove the retaining clip.
5. Remove J23653-SIR from the upper steering shaft.





6. Remove the shaft lock shield assembly (1).
7. Remove the turn signal cancel cam assembly (2).
8. Remove the upper bearing spring (3).

Installation Procedure





1. Install the upper bearing spring (3).
2. Install the turn signal cancel cam assembly (2).
3. Install the shaft lock shield assembly (1).
4. Install a new bearing retainer.
5. Using J23653-SIR depress the shaft lock shield assembly.
6. Push the bearing retainer into place.
7. Remove the J23653-SIR from the steering shaft.
8. Install the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in Restraint Systems.
9. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.