HVAC System - Automatic
HVAC CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
1. Remove the IP cluster trim plate bezel.
2. Remove the HVAC control module retaining screws.
3. Pull the HVAC control module out from the IP.
4. Disconnect the aspirator hose (1) from the HVAC control module.
5. Disconnect the electrical connector from the HVAC control module.
6. Remove the HVAC control module.
INSTALLATION PROCEDURE
1. Connect the electrical connector to the HVAC control module.
2. Connect the aspirator hose (1) to the HVAC control module.
3. Install the HVAC control module to the IP.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the HVAC control module retaining screws.
Tighten
Tighten the screws to 2.5 N.m (22 lb in).
5. Install the IP cluster trim plate bezel.