Console Replacement - Front Floor (D06)

Console Replacement - Front Floor (D06)

Removal Procedure

1. Apply the parking brake.
2. Position the transaxle shift lever to the LOW position.
3. Remove the floor console trim plate. Refer to Trim Plate Replacement - Console Front (Trim Plate Replacement - Console Front) .




4. Remove the floor console rear compartment mat.




5. Remove the floor console rear compartment bolts.
6. Remove the floor console bracket bolts rearward of the transaxle shift lever.




7. Remove the floor console horizontal bolts near the instrument panel (IP).
8. Remove the floor console power accessory port. Refer to Accessory Power Receptacle Replacement - Floor Console




10. Disconnect the wiring harness from the floor console.




11. Pull the floor console rearward in order to release the retainers from the IP.




12. Depress the front edge of the shifter trim plate in order to pull back the floor console for removal.
13. Remove the floor console from the vehicle.



Installation Procedure





1. Position the floor console to the vehicle.
2. Connect the electrical connectors to the floor console.
3. Align the floor console over the transaxle shifter and position the floor console retainers to the IP.




4. Push the floor console forward into the retainers in the IP until fully seated.





Notice: Refer to Fastener Notice in Cautions and Notices.

5. Install the floor console horizontal bolts near the IP.

Tighten the floor console horizontal bolts to 5 N.m (44 lb in).





6. Install the floor console bracket bolts at the rear of the transaxle shifter lever.

Tighten the floor console bracket bolts to 5 N.m (44 lb in).

7. Install the floor console rear compartment bolts.

Tighten the floor console rear compartment bolts to 5 N.m (44 lb in).





8. Install the floor console rear compartment mat.
9. Install the floor console trim plate. Refer to Trim Plate Replacement - Console Front (Trim Plate Replacement - Console Front) .
10. Install the floor console power accessory port.
11. Install the floor console lighter.
12. Reposition the transaxle shift lever to the PARK position.
13. Release the parking brake.