Procedures

1. Relieve the fuel system fuel pressure. Refer to Fuel Pressure Relief Procedure.
2. Remove the fuel sender assembly.
3. Use a hand operated fuel pump device in order to drain the fuel through the fuel sender access panel.

CAUTION: Do not drain the fuel into an open container. Never store the fuel in an open container due to the possibility of a fire or an explosion.

NOTE: Do not drain fuel through the fuel tank filler pipe in order to prevent damage to the fuel tank filler pipe check-ball.

4. Install the fuel sender assembly.
5. Remove the fuel tank filler pipe cap.
6. Add fuel.
7. Install the fuel tank filler pipe cap.
8. Connect the negative battery cable.
9. Inspect the fuel system for leaks by performing the following steps:
9.1. Turn ON the ignition switch for 2 seconds.
9.2. Turn OFF the ignition switch for 10 seconds.
9.3. Turn ON the ignition switch.
9.4. Inspect for fuel leaks.